Datasheet

Page 12
5. Programming with bootloader
Microcontroller is preprogrammed with USB UART Bootloader,
which can be used to upload new device rmware. To trans-
fer rmware .HEX le from a PC to MCU you need to use mikro-
Bootloader USB UART application, which can be downloaded from:
Upon download, unzip it to desired location and start the
mikroBootloader application:
http://www.mikroe.com/smartglcd/
note
Figure 5-1: mikroBootloader window
mikroBootloader software
01
When you start mikroBootloader software a window
should appear, as shown in the image above.
Before starting mikroBootloader software, connect SmartGLCD
to a PC using a USB cable provided with the package.