User manual

mikroPascal PRO for dsPIC30/33 and PIC24
MikroElektronika
562
TRISB10_bit := 1; // Set RB10 as input
TRISB11_bit := 1; // Set RB11 as input
TRISB12_bit := 1; // Set RB12 as input
{*
* init display for 240 pixel width and 128 pixel height
* 8 bits character width
* data bus on MCP23S17 portB
* control bus on MCP23S17 portA
* bit 2 is !WR
* bit 1 is !RD
* bit 0 is !CD
* bit 4 is RST
* chip enable, reverse on, 8x8 font internaly set in library
*}
// If Port Expander Library uses SPI1 module
SPI1_Init(); // Initialize SPI module used with PortExpander
{*
* init display for 240 pixel width and 128 pixel height
* 8 bits character width
* data bus on MCP23S17 portB
* control bus on MCP23S17 portA
* bit 2 is !WR
* bit 1 is !RD
* bit 0 is !CD
* bit 4 is RST
* chip enable, reverse on, 8x8 font internaly set in library
*}
SPI_T6963C_Cong(240, 128, 8, 0, 2, 1, 0, 4);
Delay_ms(1000);
{*
* Enable both graphics and text display at the same time
*}
SPI_T6963C_graphics(1);
SPI_T6963C_text(1);
panel := 0;
i := 0;
curs := 0;
cposx := 0;
cposy := 0;
{*
* Text messages
*}
SPI_T6963C_write_text(txt, 0, 0, SPI_T6963C_ROM_MODE_XOR);
SPI_T6963C_write_text(txt1, 0, 15, SPI_T6963C_ROM_MODE_XOR);