User manual

424
mikoC PRO for PIC32
MikroElektronika
unsigned int value;
void InitMain() {
TRISB0_bit = 1; // Set RB0 pin as input
TRISB1_bit = 1; // Set RB1 pin as input
Chip_Select = 1; // Deselect DAC
Chip_Select_Direction = 0; // Set CS# pin as Output
Soft_SPI_Init(); // Initialize Soft_SPI
}
// DAC increments (0..4095) --> output voltage (0..Vref)
void DAC_Output(unsigned int valueDAC) {
char temp;
Chip_Select = 0; // Select DAC chip
// Send High Byte
temp = (valueDAC >> 8) & 0x0F; // Store valueDAC[11..8] to temp[3..0]
temp |= 0x30; // Dene DAC setting, see MCP4921 datasheet
Soft_SPI_Write(temp); // Send high byte via Soft SPI
// Send Low Byte
temp = valueDAC; // Store valueDAC[7..0] to temp[7..0]
Soft_SPI_Write(temp); // Send low byte via Soft SPI
Chip_Select = 1; // Deselect DAC chip
}
void main() {
CHECON = 0x32;
AD1PCFG = 0xFFFF; // Congure AN pins as digital
InitMain(); // Perform main initialization
value = 2048; // When program starts, DAC gives
// the output in the mid-range
while (1) { // Endless loop
if ((RB0_bit) && (value < 4095)) { // If RB0 button is pressed
value++; // increment value
}
else {
if ((RB1_bit) && (value > 0)) { // If RB1 button is pressed
value--; // decrement value
}
}
DAC_Output(value); // Send value to DAC chip
Delay_ms(1); // Slow down key repeat pace
}
}