User manual

Table Of Contents

120

mikoC PRO for PIC32

MikroElektronika

Step Into [F7], Step Over [F8] and Step Out [Ctrl+F8] are mikroICD debugger functions that are used in stepping

mode. There is also a Real-Time mode supported by the mikroICD. Functions that are used in the Real-Time mode

are Run/Pause Debugger [F6] and Run to cursor [F4]. Pressing F4 executes the code until the program reaches the

cursor position line.

Run(Pause) Debugger [F6] and Toggle Breakpoints [F5] are mikroICD debugger functions that are used in the Real-

Time mode. Pressing F5 marks the line selected by the user for breakpoint. F6 executes code until the breakpoint

is reached. After reaching the breakpoint Debugger halts. Here in our example we will use breakpoints for writing

“mikroElektronika” on Lcd char by char. Breakpoint is set on Lcd_Chr and the program will stop every time this function

is reached. After reaching breakpoint we must press F6 again to continue the program execution.