Datasheet
Page 8
Page 9
Once we have selected the destination
project folder, let’s do the rest of the project
settings:
Step 1 - Project Settings
Figure 3-4: Enter project name and change device clock speed if necessary
01
02
03
03
01
02
Enter the name of your project. Since
we are going to blink some LEDs,
it’s appropriate to call the project
“LedBlinking”
For this demonstration, we will use the
default 80MHz clock (PLL enabled).
Clock speed depends on your target
hardware, and whether you are
using PLL or not. But however you
congureyourhardware,makesureto
specifytheexactclock(Fosc) that the
microcontroller is operating at.
Click the OK button to proceed.