User manual

mikroBasic PRO for dsPIC30/33 and PIC24
MikroElektronika
713
8. Put the J11 and J10 Jumpers in the correct position, as showed in the picture below:
9. Next, open MPLAB®, and select the appropriate device by choosing Congure › Select Device... :
10. After device selection, click on the File › Import. Open le dialog box should appear. Then, go to the project folder
and open the generated HEX le, UART.hex.
Note: This is very important, because hex le contains conguration bit settings which are essential for the proper
functioning of the user code.