User manual

270
mikoBasic PRO for dsPIC30/33 and PIC24
MikroElektronika
CANSPIRead
Prototype
sub function CANSPIRead(dim byref id as longint, dim byref Data_ as byte[8],
dim byref DataLen as byte, dim byref CAN_RX_MSG_FLAGS as byte) as byte
Description If at least one full Receive Buffer is found, it will be processed in the following way:
- Message ID is retrieved and stored to location provided by the id parameter
- Message data is retrieved and stored to a buffer provided by the data parameter
- Message length is retrieved and stored to location provided by the dataLen parameter
- Message ags are retrieved and stored to location provided by the CANSPI_RX_MSG_FLAGS
parameter
Parameters - id: message identier address
- data: an array of bytes up to 8 bytes in length
- dataLen: data length address
- CANSPI_RX_MSG_FLAGS: message ags address. For message receive ags format refer to
CANSPI_RX_MSG_FLAGS constants. See CANSPI_RX_MSG_FLAGS constants.
Returns - 0 if nothing is received
- 0xFFFF if one of the Receive Buffers is full (message received)
Requires The CANSPI module must be in a mode in which receiving is possible. See
CANSPISetOperationMode.
The CANSPI routines are supported only by MCUs with the SPI module.
MCU has to be properly connected to mikroElektronika’s CANSPI Extra Board or similar hardware.
See connection example at the bottom of this page.
Example
‘ check the CANSPI1 module for received messages. If any was received do
something.
dim msg_rcvd, rx_ags, data_len as byte
data as byte[8]
msg_id as longint
...
CANSPISetOperationMode(_CANSPI_MODE_NORMAL,0xFF) ‘ set NORMAL mode (CANSPI1
module must be in mode in which receive is possible)
...
rx_ags = 0 ‘ clear message ags
if (msg_rcvd = CANSPIRead(msg_id, data, data_len, rx_ags)) then
...
end if
Notes None.