Datasheet

MikroElektronika
7
StartUSB for AVR
STEP 6: MCU programming
After the .hex le is loaded, an information
about it will appear in the Atmel FLIP window
Information that .hex le is parsed
Click on the Run button
Click on the Start Application button
Information that .hex le verication is passed
Information that link with StartUSB for AVR is
disabled (Communication OFF)
After the MCU programming is completed, the Atmel FLIP window will become inactive.
NOTE: When the MCU programming is nished, remove jumper J3 (ENABLE BOOT) from the StarUSB for AVR
development system. Otherwise, the system will reenter bootloader mode .