Datasheet

MikroElektronika
Figure 1: CAN additional board
Figure 3: CAN additional board connection schematic
Figure 2: The back side of the CAN board
Development system/pin CAN-RX SW1/ON CAN-TX SW1/ON
EasyPIC6 RB3 P2 RB2 P3
dsPICPRO4, BIGdsPIC6 RF0, RG0 P0 RF1, RG1 P1
EasydsPIC6 RF0 P0 RF1 P1
BIGAVR PD6 P6 PD5 P5
How to connect the board?
The CAN additional board is connected to a development system via a 2x5 connector CN1 on the additional board and a 2x5
connector on the development system. The DIP switch SW1 is used to determine which port pins on the development system will be
used for CAN communication. Depending on the development system in use, it is necessary to set the appropriate switches on the
DIP switch SW1 to the ON position, table 1.
CAN additional board
The CAN additional board is used to connect a development system to devices that use CAN communication.
Key features:
- Supports 1Mb/s operation;
- Power supply in a range between 4.5 and 5.5V DC; and
- Low power consumption.
Table 1