Datasheet
6
AVRPLC16 v6
MikroElektronika
page
1.0. Connecting the development system to a power supply
In order to enable the development system to be turned on, it is necessary to provide the power supply voltage over a
screw connector CN1, Figure 1-1.
The power supply voltage provided via the CN1 screw connector may be in a range between 12 and 22V AC or 16 and
30V DC. In the latter case, it is not necessary to pay attention to polarity as the power supply module takes care of that.
When the development system is powered, it is necessary to set switch marked POWER SUPPLY to the ON position,
Figure 1-3. As soon as the development system is turned on, a green LED marked POWER will automatically illuminate.
)LJXUHProviding power supply voltage
)LJXUHPower supply voltage regulator
Figure 1-3: Power supply on/off switch
Figure 1-4: POWER LED
)LJXUHMMC/SD connector connection schematic