Datasheet
10
AVRPLC16 v6
MikroElektronika
page
Depending on the programmer that is used to program the microcontroller, it is necessary to place jumper J10 in the
appropriate position, Figure 3-5.
The on-board programmer is in use when jumper J10 is placed in the ON-BOARD position
A
The external programmer is in use when jumper J10 is placed in the EXTERNAL position
B
If necessary, the microcontroller’s programming pins may be disconnected from the programmer. Placing jumpers J1-
J5 in the Disabled position causes the programming pins to be disconnected from the programmer, and at the same
time connected to the rest of the development system. In this case they can be used as I/O pins.
A B
J1-J5 in Enabled position, the microcontroller’s programming pins are connected to the programmerA
J1-J5 in Disabled position, the microcontroller’s programming pins are not connected to the programmerB
A B
)LJXUHThe position of jumper J10
)LJXUHThe position of jumpers J1-J5