Datasheet

6
Easy24-33 v6 Development System
MikroElektronika
page
1.0. Connecting the System to a PC
6WHS
Follow the instructions provided in the relevant manuals and install the mikroProg Suite for PIC program and USB driver from the
product CD. USB drivers are essential for the proper operation of the on-board programmer.
In case you already have one of the Mikroelektronika’s dsPIC compilers installed on your PC, there is no need to reinstall USB drivers
as they are already installed along with the compiler.
6WHS
Use the USB cable to connect the development system to a PC. One end of the USB cable, with a USB connector of B type, should
be connected to the development system, as shown in Figure 1-2, whereas the other end of the cable with a USB connector of A
type should be connected to a PC. When establishing a connection, make sure that jumper J17 is placed in the USB position as
shown in Figure 1-1.
6WHS
Turn on your development system by setting the POWER SUPPLY switch to the ON position. Two LEDs marked as POWER and
USB LINK will be automatically turned on indicating that your development system is ready to use. Use the on-board programmer and
the mikroProg Suite for PIC program to dump a hex code into the microcontroller and employ the system to test and develop your
projects.
127( If some additional modules are used, such as LCD, GLCD etc, it is necessary to place them properly on the development
 V\VWHPZKLOHLWLVWXUQHGRII2WKHUZLVHHLWKHUFDQEHSHUPDQHQWO\GDPDJHG5HIHUWR¿JXUHEHORZIRUWKHSURSHUSODFLQJRI
the additional modules.
)LJXUHPlacing additional modules on the board
Figure 1-2: Connecting USB cable
1
2
)LJXUHPower supply
USB connector
AC/DC connector
POWER
SUPPLY switch
J17 power
supply selector