Datasheet

4
Easy24-33 v6 Development System
MikroElektronika
page
Introduction to Easy24-33 v6 Development System
The Easy24-33 v6
™
development system provides a development environment for programming and experimenting with PIC24
®
microcontrollers from Microchip
®
. The system includes an on-board programmer with mikroICD support providing an interface between
WKHPLFURFRQWUROOHUDQGD3&<RXDUHVLPSO\H[SHFWHGWRZULWHDSURJUDPLQRQHRIWKHGV3,&FRPSLOHUVJHQHUDWHDKH[¿OHDQG
program your microcontroller using the on-board LvPICFlash
™
programmer. Numerous modules, such as ZigBee
®
, alphanumeric
2x16 LCD, piezo buzzer, etc, are provided on the board and allow you to easily simulate the operation of the target device.
6\VWHPVSHFL¿FDWLRQ
Power supply: over an AC/DC connector (7-23V AC or 9-32V DC); or
over a USB programming cable (5V DC)
Power consumption:~40mA in idle state when all on-board modules are off
Dimension: 26,5 x 22cm (10,4 x 8,6inch)
Weight: 462g (0.89lbs)
3DFNDJHFRQWDLQV
Development system: Easy24-33 v6
CD: product CD with relevant software
Cables: USB cable
Documentation: Manuals for Easy24-33 v6, mikroProg Suite for PIC
and mikroICD, Quick gude for installing USB drivers,
Electrical schematic of the system
The mikroProg Suite for PIC program provides a complete list of all
supported microcontrollers. The latest version of this program with updated
list of supported microcontrollers can be downloaded from our website at
www.mikroe.com
Full-featured development
system for PIC24
microcontroller based devices
USB 2.0 on-board programmer
ZigBee communication is
based on the IEEE 802.15.4
standard
Built-in debugger for testing
programs in real time at
hardware level
On-board pads for placing
additional boards