Datasheet

11
Easy24-33 v6 Development System
MikroElektronika
page
6.0. Power Supply
The Easy24-33 v6 development system may use one of two power supply sources:
1. +5V PC power supply through the USB programming cable; and
2. External power supply source connected to an AC/DC connector provided on the development board.
7KH0&$YROWDJHUHJXODWRUDQG*UHW]UHFWL¿HUDUHXVHGWRHQDEOHH[WHUQDOSRZHUVXSSO\YROWDJHWREHHLWKHU$&LQWKHUDQJHRI
7V to 23V) or DC (in the range of 9V to 32V). Jumper J17 is used to select the power supply source. To make advantage of the USB
power supply, jumper J17 should be placed in the USB position. When using the external power supply, jumper J17 should be placed
in the EXT position. The development system is turned on/off by switching the position of the POWER SUPPLY switch.
Figure 6-2: Power supply source connection schematic
Powering over an
AC/DC connector
Powering over a
USB connector
Figure 6-1: Power supply
Power supply
voltage regulator
Jumper J17 as
a power supply
source selector
AC/DC connector
USB connector
POWER
SUPPLY switch