User Manual

E a s y P I C P R O v 8 M a n u a l

P A G E 13

DBG selection

The EasyPIC PRO v8 development board is equipped with the RJ-45

connector (2), allowing an external programmer/debugger to be connected.

The connector supports a wiring pinout compatible with Microchip

ICD

external programmers/debuggers. This connector also supports connection

of the RJ-12 cable, connect the RJ-12 cable by simply inserting it into the

center of the RJ-45 connector.

The DIP switch located next to the RJ-45 connector allows control of the

interface between onboard CODEGRIP module and target MCU:

ONBOARD (down): Interface is enabled. If an external debugger probe-device

is connected, there is a possible collision in communication.

EXTERNAL (up): Interface is disabled. External debugger probe-device can

reliably communicate with target MCU.

Figure 5: Programmer/debugger view

1 MCLR

VDD

GND

PGD

PGC

RJ-45 RJ-12 ICSP (MHCP)

EXT PROG/DBG PINOUT