User Manual

P A G E 4
F u s i o n f o r S T M 3 2 v 8 M a n u a l
Fusion for STM32 v8 is a development board designed for rapid development of embedded
applications. Redesigned from the ground up, it offers broad set of standard, as well as several
unique features never seen before in the world of embedded electronics: programming and
debugging over WiFi network, support for a large number of different ARM
®
Cortex
®
-M based
microcontrollers produced by ST Microelectronics, regardless of their pin number, and more.
The development board is designed so that the developer has everything that might be needed,
following the Swiss Army knife concept: a highly advanced programmer/debugger module, a
powerful and clean power supply module, a huge set of connectivity options including USB,
Ethernet, CAN (on the MCU Card, if supported), UART, as well as set of Mikroe proprietary standards
and technologies, including the well-established mikroBUS™ standard, a standardized MCU
Card socket, and a standardized 2x20 display connector. A number of interactive options is also
available, including buttons, LEDs, switches, and more... All these features are packed on a single
development board, which itself uses innovative manufacturing technologies, delivering fluid and
immersive working experience.
Fusion for STM32 v8 development board is also an integral part of the Mikroe rapid development
ecosystem. Natively supported by the Mikroe Software toolchain, backed up by hundreds of
different Click board
™
designs with their number growing on a daily basis, it covers many different
prototyping and development aspects, thus saving precious development time.