User Manual

P A G E 20
C O D E
G R I P U S E R M A N U A L
PROGRAMMING
On the bottom of the Menu item section, there is a panel which displays
different status messages during the programming process, along with the
progress bar. Each command returns a message response and displays it
on this panel. In general, messages displayed with green letters indicate a
successful execution, while messages displayed with red letters indicate
an error during the execution of specific command.
Troubleshooting steps required for resolving of issues reported during the
execution of the programming commands are listed at the end of this
manual, in the Troubleshooting section.
5.1.1 Programming
The Programming Menu item displays all the commands, parameters, and
other information, related to the programming process itself.
When the Programming Menu item is clicked, a quick summary of the
selected programming options is displayed on the top of the Menu item
section, grouped under a label which displays the name of the target MCU:
the selected MCU vendor, the programming protocol, connection speed,
the flash size of the target MCU, the connection type, and the reset type.
Below is the interface used to select and display the program file .bin or
.hex file, ready to be uploaded to the target MCU or examined by using a set
of options, accessible by clicking the FLASH button.
There is also the programming interface, composed of a set of buttons,
used to perform various programming commands. These commands will
be explained in this chapter.