Datasheet

MikroElektronika
Figure 1: TouchPanel Controller PROTO additional board
How to connect the board?
The TouchPanel Controller PROTO additional board can be easily connected to a microcontroller or some other device
via a 1x6 connector CN1. Connection between the additional board and a touch panel is established via the CN2
connector provided on the additional board.
How to use the board?
A touch panel is a transparent touch sensitive foil. In order to register any touch, it is necessary to connect the touch
panel to this additional board. The principle of the touch panel operation is based on the voltage change caused by a
touch or pressure applied to the touch screen. Voltage change detection is enabled due to the touch screen design. It is
composed of two exible sheets coated with a resistive material separated by an air gap. In order to detect a contact, it
is necessary to apply voltage to one of these two sheets (DRIVEA for example). When contact is made, the two sheets
are pressed together and the second sheet measures the voltage in the pressed point as a distance along the rst
sheet. The measured distance is referred to as X-axis (BOTTOM). As soon as this data is aquired, the same voltage is
applied to the second sheet (DRIVEB). Now, the rst sheet measures the distance referred to as Y-axis (LEFT).
Here you can nd examples for the TouchPanel Controller PROTO board:
http://www.mikroe.com/eng/products/view/200/touchpanel-controller-proto/
TouchPanel Controller PROTO
The TouchPanel Controller PROTO additional board is used to connect a touch panel to a microcontroller or other
device.
Key features:
- Connection established via a 1x6 connector CN1;
- Low power consumption; and
- 3.3V or 5V power supply voltage.