User Manual

Hexiwear Workstation
Page 9
How to properly dock Hexiwear?
CONNECTOR
Before docking Hexiwear, the power supply should be turned off . Images below show how to correctly dock Hexiwear. First, make sure that the orientation of the
female mezzanine connector matches the position of the connector on the Hexiwear Workstation board. Place Hexiwear above the printed hexagonal marking
on the workstation board, as shown in Figure 7. Slowly move Hexiwear down towards the board, until connectors make contact. Making sure that the alignment
of the connectors is good, gently press Hexiwear, until contacts are fi rmly coupled, as shown in Figure 7. Now the power can be turned back ON.
Figure 8:
Properly docked Hexiwear
3
Figure 7:
Make sure that the female connector of the
Hexiwear is properly oriented in respect to the
male counterpart on the Workstation board
2
Figure 6:
Hexiwear Workstation board has printed
markings, which are useful to correctly
position the Hexiwear before docking
1