User Manual

Hexiwear Workstation

Page 7

POWER SUPPLY

How to power the board?

To power the board with USB cable, jumper J5 should be placed in USB position

(Figure 2). After that, the USB cable can be plugged in, as shown on images 1 and 2.

The Hexiwear Workstation board is now ready to be powered ON by using the power

switch (SW1).

1. With USB cable

To power the board via the barrel connector, jumper J5 should be placed in EXT

position (Figure 3). After that, the power cable can be plugged in, as shown on images

3 and 4. The Hexiwear Workstation board is now ready to be powered ON by using the

power switch (SW1).

2. By using wall-adapter

To power the board via the screw terminal, jumper J5 should be placed in EXT position

(Figure 4). After that, the power cable can be fastened by the terminal screws,

as shown on images 5 and 6. The Hexiwear Workstation board is now ready to be

powered ON by using the power switch (SW1).

3. With laboratory power supply

The Hexiwear Workstation board features an

eﬃ cient and clean power supply, which provides

stable voltage and current levels, necessary for

powering each part of the board.

POWER SUPPLY:

Via DC connector or screw

terminals (7V to 23V AC or 9V to

32V DC), or via USB cable (5V DC).

POWER CAPACITY:

Up to 500mA with USB, and up to

1.6mA with external power supply.