User Manual

Page 16
Hexiwear Workstation
PROGRAMMING
Debugger Commands
Here is a short overview of which debugging commands are supported in MikroElektronika compilers. You can see what each command does, and what are their shortcuts when
you are in debugging mode. It will give you some general picture of what your debugger can do.
ICONS
[F9]
[F6]
[Ctrl + F2]
[F7]
[F8]
[Ctrl + F8]
[F4]
[F5]
[Shift+F4]
[Shift+Ctrl+F5]
[F2]
Starts Debugger.
Run/Pause Debugger.
Stops Debugger.
Executes the current program line, then halts. If the executed program line calls another routine, the
debugger steps into the routine and halts after executing the first instruction within it.
Executes the current program line, then halts. If the executed program line calls another routine, the debugger will
not step into it. The whole routine will be executed and the debugger halts at the first instruction following the call.
Executes all remaining program lines within the subroutine. The debugger halts immediately upon
exiting the subroutine.
Toggle breakpoints option sets new breakpoints or removes those already
set at the current cursor position.
Shows/Hides window with all breakpoints
Delete selected breakpoints
Opens window with available interrupts
Executes the program until reaching the cursor position.
SHORTCUT DESCRIPTION
COMMAND NAME
Start Debugger
Run/Pause Debugger
Stop Debugger
Step Into
Step Over
Step Out
Run To Cursor
Toggle Breakpoint
Show/Hide breakpoints
Clears breakpoints
Jump to interrupt