User Manual

Page 8
mikroBUS
™
standard specications mikroBUS
™
socket standard
Printed vertically. In this case, MOSI
turns into SDO and MISO turns into SDI.
1 1
1
Alternative front markings positioning
2
)
Pin markings 3
)
Silkscreen outline
It’s not always possible to retain the full silkscreen markings (either because the space between the pins is populated with other
components, or the socket is near the edge of the board). In those cases, designers should follow these guidelines.
Shortened to include only the
default pin names of the mikroBUS
™
standard
To save space, pin markings can be: The silkscreen outline can also be
left out...
...but the bottom right notch should
be preserved because it ensures
proper add-on board insertion.
- A - - B -
1
)
mikroBUS
™
logo
Anywhere in the space between
the pins (requires pin names to be
printed out vertically)
In the bottom position without the mikroBUS
™
type —
however, the full logo must still be
present on the backside of the board.
1
11
When the logo can’t be printed in the default top position, it can be placed:
- A - - B - - C -