User Manual

Page 10
You can program the microcontroller with a bootloader
which is preprogrammed by default. To transfer .hex file
from a PC to MCU you need bootloader software (UART
mikroBootloader) which can be downloaded from:
3.1 Programming with mikroBootloader
Figure 3-2: USB UART mikroBootloader window
step 1 – Connecting clicker 2 for PIC18FK
01
01
To start, connect the USB cable, or if already connected
press the Reset button on your clicker 2 for PIC18FK. Click
the Connect button within 5s to enter the bootloader mode,
otherwise existing microcontroller program will execute.
After the mikroBootloader software is downloaded,
unzip it to desired location and start it.
https://download.mikroe.com/examples/starter-boards/
clicker-2/pic18fk/clicker-2-pic18fk-mikrobootloader-v100.zip
clicker 2 for PIC18FK Bootloader
WinRAR ZIP archive
clicker 2 for PIC18FK Bootloader
File folder
Software
File folder
mikroBootloader.exe
Bootloader tool for mikroElektron...
mikroElektronika
clicker 2 for PIC18FK PIC18F67K40 UART
Bootloader v1.0.0.hex
HEX File
Firmware
File folder