Datasheet

MikroElektronika
Figure 2: LIN additional board connection schematic
Figure 3: Dimensions of the LIN additional board
How to use the board?
The LIN board receives data from the development system via UART communication, converts it so that it can be sent
further via the LIN network. Jumper J1 is used to turn on/off master mode. When this jumper is placed, tha additional
board is congured to operate in master mode. Similarly, when this jumper is removed, the additional board operates
as a slave device. Jumper J2 is used to set the additional board to normal or alternative “slope” mode.
Here you can nd examples for the LIN additional board: http://www.mikroe.com/eng/products/view/176/lin-board/