Datasheet

MikroElektronika
2
Ethernet Connector
Figure 1: Ethernet connector additional board
Connection:
The additional board can be connected to a microcontroller that has integrated ethernet controller or any other device
that features adequate ethernet controller.
For connection with a device, the additional board uses pads CN1. In order to connect the additional board to ethernet
network, it is necessary to plug network cable into ethernet connector CN2.
Pinout:
Pads pinout:
- LEDA: Signal LED output (indicates receiving data rate);
- LEDB: Signal LED output (indicates transmission data rate);
- TPIN+: Differential Ethernet Receive Plus Signal Input;
- TPIN-: Differential Ethernet Receive Minus Signal Input;
- TPOUT+: Differential Ethernet Transmit Plus Signal Output;
- TPOUT-: Differential Ethernet Transmit Minus Signal Output;
- VCC3.3: 3.3V power supply input; and
- GND: Ground.
Ethernet Connector
The Ethernet Connector is a simple, yet effective solution for adding reliable connection capability to your ethernet-
supporting device. Board contains 10/100 Base-T RJ45 connector and surrounding electronics for stable and reliable
ethernet operation.
Key features:
- RJ45 ethernet connector;
- 3.3V DC power supply.