User Manual

GND GND
VCC
J1
R1
2K2
LD1
GND
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
MIKROBUS DEVICE CONN.
1
2
3
4
6
5
U1
RPI-1035
R3 22K R2 22K
GND GND
VCCVCC
R4 150
VCC
GND
Vout2Vout1
Vout2
Vout1
VCC
GND
R6
2K2
R1
R2
Q1
PDTC114EU
GND
R5
2K2
R1
R2
Q2
PDTC114EU
Vout2
Vout1
LD2
LD3
VCC
VCC
C1
100nF
GND
VCC
8. Code examples
MikroElektronika oers free tech support
(www.mikroe.com/support) until the end of
the product’s lifetime, so if something goes
wrong, we’re ready and willing to help!
Once you have done all the necessary
preparations, it’s time to get your click
™
board
up and running. We have provided examples
for mikroC
™
, mikroBasic
™
and mikroPascal
™
compilers on our Libstock website. Just
download them and you are ready to start.
.com
6. Dimensions
MikroElektronika assumes no responsibility
or liability for any errors or inaccuracies
that may appear in the present document.
Specication and information contained in
the present schematic are subject to change
at any time without notice.
Copyright © 2015 MikroElektronika.
All rights reserved.
mm mils
LENGTH
28.5 1122
WIDTH
25.4 1000
HEIGHT
4 157.5
5. Schematic
7. SMD jumper 10. Disclaimer
9. Support
25.4 mm / 1000 mils
28.5 mm / 1122 mils
There is one zero-
ohm SMD jumper
J1 used to select
whether 3.3V or 5V
I/O voltage level is
used. Jumper J1
is soldered in 3.3V position by default.