Datasheet

STEP 1 - Remove wheels from one side

The Buggy’s main board is packed in the box with

wheels attached. Remove both wheels from the

left side of the board, by pulling on them.

STEP 4 - Insert battery holder tabs

Look for the two smallest pieces of PCB in the

box. Those are the supporting tabs that keep the

battery in place. Pick either one and place it in the

sockets on either side of the board, so that the

curved side is facing outwards

STEP 2 - Connect the battery

Pull the battery wire under the rail and attach it

to the battery connector.

STEP 5 - Solder battery holder tabs

Hold the battery-holder tab and ip the

main board so that the battery is now facing

downwards. Solder the tab. Repeat step 4 and 5

for the second battery-holder tab.

STEP 3 - Insert the battery

Push the whole battery under the rail. Be careful not

to pinch the wire. The battery should t squarely

between Buggy’s four motors.

STEP 6 - Reattach the wheels

The axle and the socket on the wheel are not

completely round, so be careful to correctly align

them before pushing the wheel towards the axle.