User Manual

RF4
RE9
RD0
RF2
RD4
RF5
RF8
RE8
RA2
5V
RA2
5V
RA3
RD5
RA3
GND
RX
Interrupt line
PWM line
RX
PWM line
TX
TX
Interrupt line
SCL
5V power supply
SCL
5V power supply
SDA
Reference ground
SDA
Reference ground
UART2 lines
UART1 lines
I
2
C2 lines
I
2
C2 lines
RG6
RB4
RG6
RB0
3.3V
RG7
3.3V
RB2
RG7
RE2
GND
RG8
GND
RB1
RG8
RG13
SPI2
lines
SPI2
lines
SCK
Analog line
SCK
Analog line
3.3V power supply
MISO
3.3V power supply
MISO
Digital lines*
Reference ground
MOSI
Reference ground
MOSI
Figure 9-1: mikroBUS
™
individual and shared lines
Clicker 2 for PIC32MX employs a solution to optimize
the use of available pins and MCU I/Os. The PWM
SEL jumper (Figure 9-2) enables two modes of
use for the second available PWM line:
1
The default position of the jumper is for
applications when you’re not using the PWM line on
the 1x26 pinout on the right side of the board. This
keeps this PWM available through mikroBUS
™
2
2
If you resolder the jumper into the second
position, it would turn the PWM line on mikroBUS
™
2 into a GPIO. You would use this in scenarios
where you already utilized the PWM through the
1x26 pinout (which would make the PWM pin on
mikroBUS
™
2 unusable)
Digital lines*
Figure 9-2:
PWM SEL jumper
9.1 PWM jumper selection