Datasheet
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specification and information contained in the present schematic are subject to change at any time without notice. Copyright © 2014 MikroElektronika. All rights reserved.
5. Illuminance click
™
board schematic
8. Support
7. Code examples
MikroElektronika oers free tech support
(www.mikroe.com/support) until the end
of the product’s lifetime, so if something
goes wrong, we’re ready and willing to help!
Once you have done all the necessary
preparations, it’s time to get your click
™
board
up and running. We have provided examples
for mikroC
™
, mikroBasic
™
and mikroPascal
™
compilers on our Libstock website. Just
download them and you are ready to start.
6. I
2
C Address selection
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
MIKROBUS DEVICE CONN.
R1
2K2
LD1
VCC-3.3VCC-3.3
DATA
CLK
VCC-3.3
C1
100nF
VCC-3.3
R2
10K
R3
10K
VCC-3.3
DATA1
2
3
5
4
6
VDD
ADR
SDA
GND SCL
INT
U1
TSL2561
CLK
INT
R4
10K
INT
J1
The J1 jumper on Illuminance click
™
allows
you to switch between three available I
2
C
addresses. To select an address, switch the
jumper between logic 1 (default) and logic 0
positions, or unsolder it completely .
.com