Datasheet

Page 17
The microcontroller can also be
programmed with the ST-LINK V2
programmer and mikroProg Suite
™
for ARM
®
software. This programmer
connects with the clicker 2 board via
mikroProg to ST-LINK V2 adapter
(Figure 3-11).
3.3 Programming with ST-LINK V2 programmer
Figure 3-11:
mikroProg
™
to
ST-LINK
™
V2
adaper
Page 17
In order to adjust the ST-LINK
™
V2 programmer to
be connected to the development system, it is
necessary to provide the appropriate adapter
such as the mikroProg to ST-LINK V2 adapter.
2x5 headers should be rst soldered on
the CN3 connector pads. Then you should
plug the adapter into the ST-LINK V2
programmer (2x10 header), and plug
an IDC10 at cable in headers,
Figure 3-12.
Figure 3-12:
Connecting
ST-LINK
™
V2
programmer