Datasheet

Page 16
04
On-board mikroProg
™
programmer requires special programming software called mikroProg Suite
™
for ARM
®
. This software is used for programming of all supported microcontroller families with
ARM
®
Cortex
™
-M3 and Cortex
™
-M4 cores. The software has an intuitive interface and SingleClick
™
programming technology. To begin, rst locate the installation archive on the link bellow:
mikroProg Suite
™
for ARM
®
software
After downloading, extract the package and double click the executable setup le, to start installation.
Figure 3-10:
mikroProg Suite
™
for ARM
®
window
Quick guide
Click the Detect MCU button in order to recognize the device ID.
Click the Read button to read the entire microcontroller memory.
You can click the Save button to save it to the target HEX le.
If you want to write the HEX le into the microcontroller, rst
make sure to load the target HEX le using the Load button.
Then click the Write button to begin programming.
Click the Erase button to clear the microcontroller memory.
01
02
03
http://www.mikroe.com/downloads/get/1809/mikroprog_suite_for_arm.zip