Datasheet

RC7
RB2
RG0
RG2
RG3
RC6
RC6
RB3
RD6
5V
RD6
5V
RD5
RD5
RD5
GND
RX
Interrupt line
PWM line
RX
PWM line
TX
TX
Interrupt line
SCL
5V power supply
SCL
5V power supply
SDA
Reference ground
SDA
Reference ground
UART1 lines
UART1 lines
I
2
C2 lines
I
2
C2 lines
RC3
RA1
RC3
RA0
3.3V
RC4
3.3V
RD0
RC4
RD2
GND
RC5
GND
RD1
RC5
RD3
SPI1
lines
SPI1
lines
SCK
Analog line
SCK
Analog line
3.3V power supply
MISO
3.3V power supply
MISO
Digital lines*
Reference ground
MOSI
Reference ground
MOSI
Figure 9-1: mikroBUS
™
individual and shared lines
9.1 mikroBUS
™
pinouts
clicker 2 for PIC18FJ employs a solution to optimize
the use of available pins and MCU I/Os. The PWM
SEL jumper (Figure 9-2) enables two modes of
use for the second available PWM line:
1
The default position of the jumper is for
applications when you’re not using the PWM line on
the 1x26 pinout on the right side of the board. This
keeps this PWM available through mikroBUS
™
2
2
If you resolder the jumper into the second
position, it would turn the PWM line on mikroBUS
™
2 into a GPIO. You would use this in scenarios
where you already utilized the PWM through the
1x26 pinout (which would make the PWM pin on
mikroBUS
™
2 unusable)
Digital lines*
Figure 9-2:
PWM SEL jumper
Page 27