Datasheet
8. Support
7. Code examples
.com
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specification and information contained in the present schematic are subject to change at any time without notice. Copyright © 2014 MikroElektronika. All rights reserved.
5. Thumbstick click
™
board schematic
MikroElektronika oers free tech support
(www.mikroe.com/support) until the end
of the product’s lifetime, so if something
goes wrong, we’re ready and willing to help!
Once you have done all the necessary
preparations, it’s time to get your click
™
board
up and running. We have provided examples
for mikroC
™
, mikroBasic
™
and mikroPascal
™
compilers on our Libstock website. Just
download them and you are ready to start.
There is a single SMD jumper (zero-ohm
resistor) J1 which is used to select between
3.3V or 5V power supplies. By default, it’s
soldered in the 3.3V position.
6. SMD jumper