Datasheet

2 3
OLED C click Manual v100
0 100000 027097
click
™
BOARD
www.mikroe.com
2. Soldering the headers
1. Introduction
3. Plugging the board in
Once you have soldered the headers your
board is ready to be placed into the desired
mikroBUS
™
socket. Make sure to align the
cut in the lower-right part of the board with
the markings on the silkscreen at the
mikroBUS
™
socket. If all the pins
are aligned correctly, push the
board all the way into the socket.
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder
the pins carefully.
Turn the board upside down so that
the bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
Before using your click
™
board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
4. Essential features
1
OLED displays are made from a thin lm of
organic compound that emits light when
exposed to a current. They are bright,
have a wide viewing angle and low power
consumption (20mA maximum). The display
on OLED C click
™
is 19.8 x 19.8mm with
a 96 x 96px resolution. The SEPS114A
controller has built-in functionalities like
screen saver (vertical scroll, horizontal
panning, fade in/out), programmable panel
size, power save mode and so forth.
OLED C click
™
OLED C click
™
lets you add a small but bright
and crisp color display to your design. It
carries a passive matrix OLED (PMOLED)
display capable of displaying over 65k
colors, and a SEPS114A display driver and
controller IC. OLED C click
™
communicates
with the target board through mikroBUS
™
SPI lines: CS, SCK, and MOSI (SDI); and AN
(R/W), PWM (A/C) and RST lines. OLED C
click
™
is designed to use a 3.3V power
supply only. Small displays like these are
ideal for displaying color icons, txt or images.