Datasheet

1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS
™
socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at
the mikroBUS
™
socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Application and features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
Before using your click
™
board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
PROTO click Manual
ver. 1.00
0 100000 025192
PROTO click
™
is an accessory board in
mikroBUS
™
form factor. It features 10x11
prototyping area as well as additional power
pads. It can be used to assemble custom
electronics thus creating a custom click
™
board. PROTO click
™
contains mikroBUS
™
I
2
C
(SDA, SCL), SPI (MISO, MOSI, SCK, CS), UART
(TX, RX), PWM, INT, AN and RST lines from
the target board microcontroller. The board
provides 3.3 V and 5 V power supply.
PROTO click
™
board is a cheap and eective
solution for creating click board of your
own design. Add sensors, drivers, passive
components and make the click board
which suits your project needs. You can
use it with all your favorite development
boards with mikroBUS
™
sockets.
PROTO click