Datasheet

Page 10

You can program the microcontroller with bootloader which is pre

programmed into the device by default. To transfer .HEX le from

a PC to MCU you need bootloader software (mikroBootloader

USB HID) which can be downloaded from:

After software is downloaded unzip it to desired location and

start mikroBootloader USB HID software.

http://www.mikroe.com/downloads/get/1976/

mikromedia_plus_mikrobootloader_v210.zip

Programming with mikroBootloader

Figure 3-2: USB HID mikroBootloader window

step 1 – Connecting mikromedia

To start connect the USB cable or (if already connected)

press the Reset button on your mikromedia+ board. Click

the Connect button within 5s to enter the bootloader mode,

otherwise existing microcontroller program will execute.