Datasheet
8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
Communication lines voltage level can be
in range between 3.3V and 5V. On-board
transistors are used to drive relays by
current sinking.
5. RELAY click
™
Board Schematic
CN1
CN2
LD3
LD1
LD2
REL1 G6D1AASIDC5
REL2 G6D1AASIDC5
V2
V1
VCC
VCC VCC
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
VCC
R3
2K2
VCC
C1
10uF
VCC
R1
10K
R2
2K2
D1
D2
VCC
R1
R2
Q2
PDTC114EU
R1
R2
Q1
PDTC114EU
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. Communication lines