Datasheet

1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all the way
into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click board
™
, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
RELAY click Manual
ver. 1.00b
0 100000 024393
RELAY click
™
is an add-on board in
mikroBUS
™
form factor. It’s a compact and
easy solution for adding RELAY to your
design. It features two G6D1AASI-5DC
power PCB relay modules as well as two
screw terminals. RELAY click
™
communicates
with target board microcontroller via
mikroBUS
™
PWM (RL1) and CS (RL2) pins.
The board is designed to use 5V power
supply only. LED diode (Green) indicates the
presence of power supply.
RELAY click
Relay is an electrical switch used to
terminate or establish circuit using a low
power signal from a microcontroller. Relay
provides complete electrical isolation
between microcontroller and controlled
circuits. Use the RELAY click
™
board with
it’s two G6D1AASI-5DC relays to control
various devices with up to 5A, 250V AC/30V
DC loads.