Datasheet
8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
5. IrThermo Click™ Board Schematic
VCC
R2
10K
VCC
R1
2K2
LD1
VCC VCC
C1
100nF
R3
10K
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
21
4 3
U1
MLX90614ESF-AAA
(5V Supply Voltage)
SCL
SDA/PWM
VCC
PWM
SDA
SCL
J1
J2 J3
SDA
PWM
VCC
SDA/PWM
PWR SEL
SCL
MIKROBUS DEVICE CONN.
MLX90614 E SF - A A A
Part
Number
Temp
Code
Package
Code
Supply
Voltage
Number of
Thermopiles
Package
Option
-
MLX90614 -40۫C...85۫C SF (TO-39) 5V single zone standard-
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. SMD Jumpers
By placing SMD jum-
pers J2 and J3 in
appropriate position
(I
2
C or PWM) you will
be able to change
communication
interface between target board micro-
controller and MLX90614 module. Jumpers
are soldered in I
2
C position by default.