Datasheet

1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
0 100000 022849
IrThermo click - 5V
ver. 1.00
IrThermo Click™ is an accessory board in
mikroBUS
™
form factor. It’s a compact
and easy solution for adding InfraRed (Ir)
Thermometer to your design. It features
MLX90614ESF-AAA single zone Infrared
(Ir) thermometer module. IrThermo
Click™ communicates with target board
microcontroller via mikroBUS
™
I
2
C lines
(SCL, SDA) and PWM line. The board is
designed to use 5V power supply only.
LED diode indicates the presence of
power supply.
IrThermo click
IrThermo Click™ with it’s MLX90614 IC is a
compact solution for non contact temperature
measurements. The MLX90614 contains
17-bit ADC , powerful DSP unit and 10-bit
PWM. It is calibrated in wide temperature
ranges: -40 to 85°C for the ambient
temperature and -70 to +380 °C for the
object temperature (-20 to 120 °C in PWM
mode). These features make this board
ideal for automotive, industrial control, body
temperature and many more.
5V