User manual

page 2
The PT MCU CARD 1 is shown on Figure 1. It contains PIC24EP512GU810 microcontroller with on-chip peripherals and is a great choice for both beginners and professionals.
After testing and building the nal program, this card can also be taken out of the board socket and used in your nal device.
Card information
PIC24EP512GU810 has 70 MIPS CPU speed, 512K bytes of program memory
(ash), 52K bytes of data memory. It has USB 2.0 OTG, 83 General purpose I/O
pins, 9 16-bit timers, 2 ADC (32 ch), 4 UARTs, internal 7.37 MHz and 32kHz
oscillators, internal Real time clock (RTC), 2 I2C, 4 SPI and 2 CAN controllers.
It also contains 3 analog comparators and programming and debugging
interface.
8MHz crystal oscillator. We carefully chose the most convenient crystal
value that provides clock frequency which can be used directly, or with the PLL
multipliers to create higher MCU clock value. MCU card also contains 32.768 kHz
crystal oscillator which provides external clock waveform for RTCC module.
2
3
1
1
2
Figure 1: MCU card with PIC24EP512GU810
USB communications lines. These two jumpers, when in USB position, connect
D+ and D- lines of the on-board USB connector with RG2 and RG3 microcontroller
pins. Since PIC24EP512GU810 supports USB, jumpers are in USB position.
3
v7