Datasheet

dsPIC33FJXXXGPX06A/X08A/X10A
DS70593D-page 276  2009-2012 Microchip Technology Inc.
TABLE 25-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
(3)
Typical
(2)
Max Units Conditions
Power-Down Current (I
PD)
(1)
DC60d 50 200 A-40°C
3.3V Base Power-Down Current
(3,4)
DC60a 50 200 A+25°C
DC60b 200 500 A+85°C
DC60c 600 1000 A +125°C
DC61d 8 13 A-40°C
3.3V Watchdog Timer Current: IWDT
(3,5)
DC61a 10 15 A+25°C
DC61b 12 20 A+85°C
DC61c 13 25 A +125°C
Note 1: I
PD (Sleep) current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled, all peripheral modules except the ADC are disabled
(PMDx bits are all ‘1’s). The following ADC settings are enabled for each ADC module (ADCx) prior to
executing the PWRSAV instruction: ADON = 1, VCFG = 1, AD12B = 1 and ADxMD = 0.
• VREGS bit (RCON<8>) = 0 (i.e., core regulator is set to stand-by while the device is in Sleep mode)
• RTCC is disabled.
• JTAG is disabled
2: Data in the “Typ” column is at 3.3V, +25ºC unless otherwise stated.
3: The Watchdog Timer Current is the additional current consumed when the WDT module is enabled. This
current should be added to the base I
PD current.
4: These currents are measured on the device containing the most memory in this family.
5: These parameters are characterized, but are not tested in manufacturing.