Datasheet

 2009-2012 Microchip Technology Inc. DS70593D-page 275
dsPIC33FJXXXGPX06A/X08A/X10A
TABLE 25-6: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
(3)
Typical
(2)
Max Units Conditions
Idle Current (I
IDLE): Core OFF Clock ON Base Current
(1)
DC40d 3 25 mA -40°C
3.3V
10 MIPS
DC40a 3 25 mA +25°C
DC40b 3 25 mA +85°C
DC40c 3 25 mA +125°C
DC41d 4 25 mA -40°C
3.3V 16 MIPS
DC41a 5 25 mA +25°C
DC41b 6 25 mA +85°C
DC41c 6 25 mA +125°C
DC42d 8 25 mA -40°C
3.3V 20 MIPS
DC42a 9 25 mA +25°C
DC42b 10 25 mA +85°C
DC42c 10 25 mA +125°C
DC43a 15 25 mA +25°C
3.3V 30 MIPS
25DC43d 15 mA -40°C
DC43b 15 25 mA +85°C
DC43c 15 25 mA +125°C
DC44d 16 25 mA -40°C
3.3V 40 MIPS
DC44a 16 25 mA +25°C
DC44b 16 25 mA +85°C
DC44c 16 25 mA +125°C
Note 1: Base I
IDLE current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• No peripheral modules are operating; however, every peripheral is being clocked (defined PMDx bits
are set to zero and unimplemented PMDx bits are set to one)
• JTAG is disabled
2: Data in “Typ” column is at 3.3V, +25ºC unless otherwise stated.
3: These parameters are characterized but not tested in manufacturing.