Datasheet

dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
DS70616F-page 508 Preliminary © 2009-2012 Microchip Technology Inc.
FIGURE 32-2: EXTERNAL CLOCK TIMING
Q1 Q2 Q3 Q4
OSC1
CLKO
Q1 Q2 Q3 Q4
OS20
OS25
OS30 OS30
OS40
OS41
OS31 OS31
TABLE 32-16: EXTERNAL CLOCK TIMING REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Param. Symbol Characteristic Min. Typ.
(1)
Max. Units Conditions
OS10 F
IN External CLKI Frequency
(External clocks allowed only
in EC and ECPLL modes)
DC — 60 MHz EC
Oscillator Crystal Frequency 3.5
10
32.4
—
—
32.768
10
40
33.1
MHz
MHz
kHz
XT
HS
S
OSC
OS20 TOSC TOSC = 1/FOSC 8.33
7.14
—
—
DC
DC
ns
ns
+125ºC
+85ºC
OS25 TCY Instruction Cycle Time
(2)
16.67
14.28
—
—
DC
DC
ns
ns
+125ºC
+85ºC
OS30 TosL,
TosH
External Clock in (OSC1)
High or Low Time
0.375 x TOSC — 0.625 x TOSC ns EC
OS31 TosR,
TosF
External Clock in (OSC1)
Rise or Fall Time
— — 20 ns EC
OS40 TckR CLKO Rise Time
(3)
—5.2—ns —
OS41 TckF CLKO Fall Time
(3)
—5.2—ns —
OS42 GM External Oscillator
Transconductance
(4)
—
12 — mA/V HS, V
DD = 3.3V
TA = +25ºC
6 — mA/V XT, VDD = 3.3V
T
A = +25ºC
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: Instruction cycle period (TCY) equals two times the input oscillator time base period. All specified values
are based on characterization data for that particular oscillator type under standard operating conditions
with the device executing code. Exceeding these specified limits may result in an unstable oscillator
operation and/or higher than expected current consumption. All devices are tested to operate at
“Minimum” values with an external clock applied to the OSC1 pin. When an external clock input is used,
the “Maximum” cycle time limit is “DC” (no clock) for all devices.
3: Measurements are taken in EC mode. The CLKO signal is measured on the OSC2 pin.
4: This parameter is characterized, but not tested in manufacturing.