Datasheet

© 2009-2012 Microchip Technology Inc. Preliminary DS70616F-page 397
dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
REGISTER 22-14: UxIR: USB INTERRUPT STATUS REGISTER (DEVICE MODE ONLY)
U-0 U-0 U-0 U-0 U-0 U-0 U-0 U-0
bit 15 bit 8
R/K-0, HS U-0 R/K-0, HS R/K-0, HS R/K-0, HS R/K-0, HS R-0 R/K-0, HS
STALLIF
RESUMEIF IDLEIF TRNIF SOFIF UERRIF URSTIF
bit 7 bit 0
Legend: U = Unimplemented bit, read as ‘0’
R = Readable bit K = Write ‘1’ to clear bit HS = Hardware Settable bit
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-8 Unimplemented: Read as ‘0
bit 7 STALLIF: STALL Handshake Interrupt bit
1 = A STALL handshake was sent by the peripheral during the handshake phase of the transaction in
Device mode
0 = A STALL handshake has not been sent
bit 6 Unimplemented: Read as ‘0
bit 5 RESUMEIF: Resume Interrupt bit
1 = A K-State is observed on the D+ or D- pin for 2.5 μs (differential ‘1’ for low-speed, differential ‘0’ for
full-speed)
0 = No K-State observed
bit 4 IDLEIF: Idle Detect Interrupt bit
1 = Idle condition detected (constant Idle state of 3 ms or more)
0 = No Idle condition detected
bit 3 TRNIF: Token Processing Complete Interrupt bit
1 = Processing of current token is complete; read UxSTAT register for endpoint BDT information
0 = Processing of current token not complete; clear UxSTAT register or load next token from STAT
(Clearing this bit causes the STAT FIFO to advance.)
bit 2 SOFIF: Start of Frame Token Interrupt bit
1 = A Start of Frame token was received by the peripheral
0 = A Start of Frame token has not been received by the peripheral
bit 1 UERRIF: USB Error Condition Interrupt bit (read-only)
1 = An unmasked error condition has occurred; only error states enabled in the UxEIE register can set
this bit
0 = No unmasked error condition has occurred
bit 0 URSTIF: USB Reset Interrupt bit
1 = Valid USB Reset has occurred for at least 2.5 μs; Reset state must be cleared before this bit can
be reasserted
0 = No USB Reset has occurred