Datasheet

ManualsBrandsMIKROELEKTRONIKA ManualsMikroElektronika Development KitsPCB extension board

301

302

303

304

305

306

307

308

309

310

dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814

bit 7-6 DTC<1:0>: Dead-Time Control bits

11 = Dead-Time Compensation mode

10 = Dead-time function is disabled

01 = Negative dead time actively applied for Complementary Output mode

00 = Positive dead time actively applied for all output modes

bit 5 DTCP: Dead-Time Compensation Polarity bit

(3)

When set to ‘1’:

If DTCMPx = 0, PWMxL is shortened and PWMxH is lengthened.

If DTCMPx = 1, PWMxH is shortened and PWMxL is lengthened.

When set to ‘

0’:

If DTCMPx = 0, PWMxH is shortened and PWMxL is lengthened.

If DTCMPx = 1, PWMxL is shortened and PWMxH is lengthened.

bit 4 Unimplemented: Read as ‘0’

bit 3 MTBS: Master Time Base Select bit

1 = PWM generator uses the secondary master time base for synchronization and as the clock source

for the PWM generation logic (if secondary time base is available)

0 = PWM generator uses the primary master time base for synchronization and as the clock source

for the PWM generation logic

bit 2 CAM: Center-Aligned Mode Enable bit

(2,4)

1 = Center-Aligned mode is enabled

0 = Edge-Aligned mode is enabled

bit 1 XPRES: External PWM Reset Control bit

(5)

1 = Current-limit source resets the time base for this PWM generator if it is in Independent Time Base

mode

0 = External pins do not affect PWM time base

bit 0 IUE: Immediate Update Enable bit

1 = Updates to the active MDC/PDCx/SDCx registers are immediate

0 = Updates to the active PDCx registers are synchronized to the PWM time base

Note 1: Software must clear the interrupt status here and in the corresponding IFS bit in the interrupt controller.

2: These bits should not be changed after the PWM is enabled (PTEN = 1).

3: DTC<1:0> = 11 for DTCP to be effective; otherwise, DTCP is ignored.

4: The Independent Time Base (ITB = 1) mode must be enabled to use Center-Aligned mode. If ITB = 0, the

CAM bit is ignored.

5: To operate in External Period Reset mode, the ITB bit must be ‘1’ and the CLMOD bit in the FCLCONx