Datasheet

PIC32MX5XX/6XX/7XX
DS61156G-page 200 © 2009-2011 Microchip Technology Inc.
FIGURE 31-6: TIMER1, 2, 3, 4, 5 EXTERNAL CLOCK TIMING CHARACTERISTICS
Note: Refer to Figure 31-1 for load conditions.
Tx11
Tx15
Tx10
Tx20
TMRx
OS60
TxCK
TABLE 31-23: TIMER1 EXTERNAL CLOCK TIMING REQUIREMENTS
(1)
AC CHARACTERISTICS
Standard Operating Conditions: 2.3V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C
≤ TA ≤ +105°C for V-Temp
Param.
No.
Symbol Characteristics
(2)
Min. Typical Max. Units Conditions
TA10 TTXHTxCK
High Time
Synchronous,
with prescaler
[(12.5 ns or 1 TPB)/N]
+ 25 ns
— — ns Must also meet
parameter TA15
Asynchronous,
with prescaler
10 — — ns —
TA11 T
TXLTxCK
Low Time
Synchronous,
with prescaler
[(12.5 ns or 1 TPB)/N]
+ 25 ns
— — ns Must also meet
parameter TA15
Asynchronous,
with prescaler
10 — — ns —
TA15 T
TXPTxCK
Input Period
Synchronous,
with prescaler
[(Greater of 25 ns or
2 T
PB)/N] + 30 ns
——nsV
DD > 2.7V
[(Greater of 25 ns or
2 T
PB)/N] + 50 ns
——nsV
DD < 2.7V
Asynchronous,
with prescaler
20 — — ns V
DD > 2.7V
(Note 3)
50 — — ns VDD < 2.7V
(Note 3)
OS60 FT1 SOSC1/T1CK Oscillator
Input Frequency Range
(oscillator enabled by setting
TCS bit (T1CON<1>))
32 — 100 kHz —
TA20 T
CKEXTMRL Delay from External TxCK
Clock Edge to Timer
Increment
—1T
PB —
Note 1: Timer1 is a Type A.
2: This parameter is characterized, but not tested in manufacturing.
3: N = Prescale Value (1, 8, 64, 256).