Datasheet

8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
5. Flash Click™ Board Schematic
VCC-3.3
R2
10K
CS#
SCK
SDO
SDI
VCC-3.3
R1
2K2
LD1
POWER
VCC-3.3
1
2
3
54
6
7
8
CS
SDO
WP
GND SDI
SCK
HOLD
VCC
U1
M25P80
VCC-3.3
SDO
SCK
SDI
CS#
C1
100nF
R3
10K
R4
10K
HOLD#
HOLD#
WP#
WP#
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. Power supply - 3.3V only
The board is designed to
use 3.3V power supply
only. If you need to add
serial Flash memory module
to your 5V development
board, we recommend you to use other
boards such as the SerialFlash board:
http://www.mikroe.com/eng/products/
view/441/serialash-board/