Datasheet
8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
5. THERMO Click™ Board Schematic
+3V3
SDO
SCK
R2
2K2
E1
10uF
CS#
C1
100nF
FP1
FERRITE
LD1
PWR
1
2
3
54
6
7
8
GND
T-
T+
VCC SCK
CS
SO
DNC
U1
MAX31855K
AL-
CH+
K
CN1
PCC-SMP
+3V3
VCC
SDO
SCK
CS#
VCC
R1
10K
VCC
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. Thermocouple probe
In order to use THERMO Click™ board you
need to connect the appropriate K-type
thermocouple probe (not included in the
package) into the PCC-SMP connector, as
shown in gure above.