Datasheet

mikromedia
mikromedia
™
board socket
mikromedia for PIC18FJ®
mikromedia for PIC24®
mikromedia for PIC24EP®
mikromedia for dsPIC33®
mikromedia for dsPIC33EP®
mikromedia for PIC32®
Figure 4-1: mikromedia
™
board socket
After testing and building
the nal program, this
mikromedia
™
can also be taken
out of the board socket and used
in your nal device which makes it
a great choice for both beginners and
professionals. The mikromedia
™
socket
schematic is shown on Figure 4-2
page 8
1
2
3
4
5
6
mikromedia
™
workStation v7 contains four female headers that together form a socket for specialized
small development boards with a microcontroller and on-chip modules, called mikromedia
™
boards. Two of
them are used for general purpose I/O and power pins (1x26). The other two are used for the mikroProg
™
programmer (1x5) or ICD2/3 (1x6). Before placing the mikromedia
™
board into the appropriate socket
(Page 10), you have to solder two 1x26 male headers to the side pads and one 1x5 male header for
mikroProg
™
programmer. Currently, six mikromedia
™
boards are supported, but there is a tendency to
increase the number: